Advanced Vehicle Functions V1.7 fs25-mods

Description:

Advanced Vehicle Functions Note: Four-wheel drive and differentials must be purchased separately in the shop for each desired vehicle. Important: The key bindings must be configured; nothing has been preset. Analog joystick control for throttle and brake Switchable analog drive lever Glow plug system for cold engines Display of engine speed and engine temperature in the HUD Functional handbrake Sounds when applying and releasing the handbrake Sounds from the four-wheel drive and differentials Selectable four-wheel drive Separate differential locks for the front and rear axles Four-wheel drive and differential can be purchased in the shop. Realistic compressed-air braking system for vehicles Simulated air pressure from 0 to 10 bar Speed-dependent compressor output Air consumption when braking and using the handbrake Air consumption when connecting a compressed-air trailer The handbrake cannot be released if the air pressure is too low. Reduced braking performance at low tire pressure Load-dependent vehicle center of gravity Dynamic load shifting in curves and on slopes Increased risk of tipping due to loaded trailers and raised implements Increased pushing force from heavy trailers on downhill sections Load loss with covers open and at higher driving speeds (minor) Detection of rollovers and vehicle accidents Spillage or loss of bulk material after an accident (must be loaded with a front loader) Towing service for damaged vehicles Towing costs are calculated based on the distance to the repair shop. Joint lifting and lowering of front-mounted implements Joint lifting and lowering of rear-mounted implements Simultaneous lifting and lowering of all attached implements Separate activation and deactivation of front and rear implements Simultaneous activation and deactivation of all implements Separate folding and unfolding of front and rear implements Simultaneous folding and unfolding of all implements The camera automatically rotates in the interior view when reverse gear is engaged. This can be disabled in the general settings. The helper automatically applies the handbrake in helper mode. Automatic drivetrain (intelligent automatic control of four-wheel drive and differential). The four-wheel drive has 2 systems and can be engaged at any time. The slight vibration of the interior camera is intended to simulate the running engine. The front loader can be raised and lowered faster at idle by increasing the throttle (engine speed). When starting the engine, the key or button (ignition switch) must be held down for 0.8 seconds; otherwise, the vehicle will not start (this is intended to simulate a real ignition switch).